The 3 steps to get the most out of the MasterPower method
1) CLEANING THE SKI
Carefully clean the insole (including the sides of the ski). Pass the insole several times with solvent and paper cloth until it is perfectly clean.
2) PREPARATION OF THE ROLL
Choose the Master Power product best suited to the snow conditions. With the roller running, rub the product 2/3 times on the rotating wool applicator. Warning: use only Master Power products. Traditional products are not suitable.
3) MASTER POWER PARAFFIN APPLICATION and FINISHING
Pass the ski back and forth over the roller several times, exerting slight pressure. Be careful not to stop with the ski on the roller to avoid any abrasion marks. At the end of the operation, the insole will be shiny. For a perfect success of the work it is advisable to wait a few minutes and to pass the ski on the roller after putting on a clean wool applicator. This operation will make the base even more shiny. At this point the ski is ready to be used, or, for top performance, you can proceed with the application of Masterwax hyperfluorinated powder additives.
